11.17.G73 – High Speed Peck Drilling
This command is Canned Cycle used for high speed peck drilling.
Syntax & Parameters
G73 followed by axis, R, Q, K & F values.
X, Y, Z, A, B Value – specifies the axis you wish to move following the distance to move. The distance value will be the current machine units in use.
R Value – This is the retract position in the Z axis. This value must be specified.
Q Value – The Q value is peck (incremental) value. A positive non zero Q value must be specified.
K Value – This is number of time the cycle needs to be repeated.
F Value – The F value defines the federate at which the axis will move at.
N10 G99 G73 X10 Y10 Z-8 R2 Q1 F100 N20 X20 N30 X30
- The first line moves the X & Y axis to 10mm position with retract plane set to 2mm, drilling to Z -8mm, peck of 1mm at 100 mm/minute feedrate and starts drilling.
- The second line moves X axis to 20mm position and drill a hole as per the same values.
- The third line moves X axis to 30mm position and drill a hole as per the same values.
Note: Units are defined as either inches or mm depending on your machines setup or G20 or G21 command in use.
0 of 0 users found this section helpful